女朋友水太多进去就软了,伊人久久大香线蕉av影院,被十几根触手扒开腿猛戳动漫 ,暴露yín荡女友17部分

在小型冷庫設計中要注意一些細節(jié)問題，第一是排水，在現(xiàn)行小型冷庫設計中，主要以風冷為主要方式，冷風機定期需要除霜以增加換熱效率，每個冷庫應獨立預留排水位置，一般為直徑50的PVC排水管即可，位置靠近冷風機附近冷庫外側。
In the design of cold storage should pay attention to some of the details, the first is the drainage in the current cold storage design, mainly in the air as the main way of air cooler regularly need to defrost to increase the heat exchange efficiency, each house should be independent of reserved drainage position, generally the diameter of 50 PVC drainage pipe can be positioned close to the air cooler near cold outside.
第二是排風，由于小型冷庫一般都為室內安裝，其中壓縮機的匹配比較小，考慮到制冷損耗，壓縮機一般在冷庫附近，因此冷庫排出的熱量有可能在一定的狹小空間，此時應考慮排風，以保證壓縮機組冷凝溫度的合適。排風量以不小于壓縮機組冷凝器的排風量為好。  第三是防潮，冷庫的外表成型基板用花鋁板，彩鋼板或者鍍鋅板，而冷庫由于長期低溫，附近比較潮濕，應做好防潮，尤其是保溫材料不能進水，否則隔熱效果降大為降低。
Second is the exhaust, because small refrigerator is generally for indoor installation, including compressor, relatively small, taking into account the refrigeration compressor loss, general in the refrigerator near, so cold heat discharged likely in narrow space, this time should be considered to ensure the exhaust, the compressor unit condensing temperature appropriate. The exhaust air volume is not less than the air flow rate of the condenser of the compressor unit. Third is the appearance of moisture, cold molding substrate with flower color steel plate or aluminum plate, galvanized sheet, cold storage and low temperature due to the long, near the more humid, should be moisture-proof, especially insulation materials can not drop water, otherwise heat insulation effect is greatly reduced.
在小型冷庫設計中一定要注意以上的細節(jié)，避免出現(xiàn)不必要的麻煩。
In small cold storage design must pay attention to the above details, to avoid unnecessary trouble.