女朋友水太多进去就软了,伊人久久大香线蕉av影院,被十几根触手扒开腿猛戳动漫 ,暴露yín荡女友17部分

醫藥冷庫在設計安裝過程中需要注意以下幾點：
Medicine in the refrigerator design and installation process need to pay attention to the following:
1、醫藥冷庫需要安裝在建筑強度大，地面相對平穩，且通風良好，溫度低，避光性強，雨水相對較少的地方。
1, the medicine need to install the refrigerator in building strength, relatively flat on the ground, and well ventilated, low temperature, avoid light, rain is relatively small.
2、組合式冷庫工程安裝需要一個水平的混凝土基座。基座出現基礎傾斜，凹凸的時候，必須要將基座修復平整。
2, combined cold storage engineering installation requires a level of concrete base. Base base tilt, concave and convex, must will dock repair level off.
3、醫藥冷庫冷庫工程的安裝要離開發熱器具和設備。
3, pharmaceutical refrigerator cold storage engineering installation to leave heating appliances and equipment.
4、排水管上安裝U型管，避免導致機組收到腐蝕。
4, install U tube drain, avoid corrosion causes received.
5、醫藥冷庫工程在較熱的地方，不但冷卻效率會下降，有時還會損傷冷庫保溫板，另外，保證機組正常工作的周圍溫度的范圍是在35度以內。還要留出對機組進行檢修的空間。
5, medicine, cold storage project in a hot place, not only the cooling efficiency will decline, cold storage insulation board, sometimes damage on the other hand, guarantee the normal work of the unit of the ambient temperature range is within 35 degrees. It is the space set aside for unit overhaul.
6、 拼接冷庫保溫板時注意在庫板的凸邊上完整的粘貼海綿膠帶，安裝冷庫板時不要碰撞海綿交待粘貼位置。
6, joining together refrigerator insulation board in the plate when you complete paste on the convex side of the sponge tape, installing a refrigerator plate paste position not impact the sponge.
7、冷庫內的拍水用排水管排出，會經常有水排出，所以要將排水導向能夠順暢流通的地方。
7, take water in the refrigerator with a drain discharge, often can have water, so to guide the drainage can flows smoothly.
8、排水管上一定要安裝U型管，安設U型管可防止冷氣泄露，昆蟲、老鼠的入侵。
8, a drain on must install u-shaped tube, make U tube can prevent the air leak, the invasion of insects, mice.
9、醫藥冷庫庫體安裝好后，檢查各板縫貼合情況，必要時內外均應填硅膠封閉。
9, medicine after installation of cold storage library body, check the plate seam joint, shall fill in the silica gel inside and outside the closed when necessary.
10、由于冷庫的庫板種類繁多，安裝活動冷庫是應參照“冷庫拼裝示意圖”。
10, because there are many different kinds of cold storage library board, cold storage installation activities is should consult "refrigerator assembly plan".
11、擰緊掛鉤時，應緩慢均勻用力，擰至板縫合攏，不可用力過度，以免鉤盒拔脫。
Firstly, 11, tighten the hook should slow, twist to the plate suture approach, not overexert, lest josephalbert hook box.
12、組合式冷庫隔墻板應用隔墻角鋼固定。
12, combined-type clapboard refrigerator application partition fixed Angle.
13、管路及電器安裝完成后，組合式冷庫庫板上所有的管路穿孔，必須用防水硅膠密封。
13, piping and electrical installation is completed, combined cold storage library board all pipe perforation, must use waterproof silicone seal.
14、冷庫冷藏設備安裝結束后，有時在凝土基地干透前會出現結露。在梅雨季節等濕度異常高的時候，庫板的接縫會出現結露，很小的情況下，整修庫板也會出現結露，這些都是暫時的現象,必要的時候要進行擦拭。
14, the end of the cold storage refrigeration equipment installation, and sometimes will appear in front of the concrete base dry condensation. In plum rains season when unusually high humidity, condensation, library board seam will appear under the condition of small, renovated library board also can appear condensation, these are temporary phenomenon, when it's necessary to wipe.