女朋友水太多进去就软了,伊人久久大香线蕉av影院,被十几根触手扒开腿猛戳动漫 ,暴露yín荡女友17部分

冷庫建筑從施工開始到設備安裝一般是在常溫下進行的，結構體系也處于常溫狀態；而冷庫投入使用后，其結構體系卻處于低溫環境中。
The construction of cold storage is usually carried out at room temperature from the beginning of construction to the installation of equipment, and the structure system is also at normal temperature. However, after the cold store is put into use, its structural system is at low temperature.
由于溫差大而引起的結構體系變形比普通建筑大得多，因此必須進行溫度應力計算，以防止產生“冷橋”。地坪應采取防凍措施，以防止地基隆起而造成建筑物破壞。同時應選用抗凍性強的材料，以增強結構的耐凍性、耐久性。
The deformation of the structure system caused by the large temperature difference is much larger than that of the ordinary building, so it is necessary to calculate the temperature stress in order to prevent the "cold bridge". The floor shall take antifreeze measures to prevent the damage of buildings from the ground in Keelung. At the same time, the material with strong antifreeze should be selected to enhance the frost resistance and durability of the structure.

小型冷庫的承重結構一般為梁板式結構，而大型多層冷庫多采用現澆鋼筋混凝土無梁樓蓋結構。近年來，預制裝配式的無梁樓蓋與用升板法施工的無梁樓蓋框架結構正在逐步推廣。

The load-bearing structure of the small cold storage is usually beam plate structure, and the large multi-layer cold storage is mostly used for the cast-in-place reinforced concrete beam free floor structure. In recent years, the frame structure of the beam - free floor and the construction of the prefabricated beam - free floor and the lifting plate method are being gradually popularized.
冷庫的圍護墻體結構設計除滿足強度和穩定性外，還應保持絕熱層及隔氣層的連續性，使之符合建筑熱工要求。
In addition to the strength and stability of the wall structure of the cold storage, the continuity of the adiabatic layer and the gas layer should be maintained so as to meet the thermal requirements of the building.
冷庫的屋面結構受太陽直接照射的時間較長，受氣溫變化的影響，會產生膨脹或收縮變形，宜采用預制構件，使變形在構件之間進行調整，從而減小總變形。為了防止因屋面伸縮對墻體產生的不利影響，可在屋面結構與墻體之間設計成滑動接觸面。
The roof structure of cold storage is directly irradiated by the sun for a long time, and it will expand or shrink under the influence of temperature changes. It is advisable to use precast elements to adjust the deformation between components, so as to reduce the total deformation. In order to prevent the adverse effects of the roof expansion on the wall, a sliding contact surface can be designed between the roof structure and the wall.
以上便是食品冷庫今天的分享，您還滿意嗎，歡迎關注我們的網站:http://www.sddslk.com并且關注我們的產品，我們將為您提供優良的產品，衷心的愿與您建立合作關系。
The above is the sharing of today's food cold storage. Are you satisfied? Welcome to our website: http://www.sddslk.com and pay attention to our products. We will provide you with excellent products and sincerely cooperate with you.