女朋友水太多进去就软了,伊人久久大香线蕉av影院,被十几根触手扒开腿猛戳动漫 ,暴露yín荡女友17部分

冷庫蒸發式冷凝器一般安裝在機房頂部，機房的屋頂結構需特殊處理，要求能承受蒸發式冷凝器的重量。
The freezer evaporative condenser is installed on the top of the machine room, the roof structure of the machine room needs special treatment, the weight of evaporative condenser is required.
冷庫蒸發式冷凝器安裝必須牢固可靠且通風良好，安裝時其頂部應高出鄰近建筑物300mm,或至少不低于鄰近建筑物的高度，以免排出的熱濕空氣沿墻面回流至進風口；若不能滿足上述要求時，安裝時應在蒸發式冷凝器頂部出風口上裝設漸縮口風筒，以提高出口風速和排氣高度，減少回流。
Refrigerator evaporative condenser installation must be solid and reliable and well ventilated, the top 300 mm should be higher than that of adjacent buildings when installation, or at least not less than the height of the adjacent buildings, in order to avoid the discharge of hot wet air along the wall back to the inlet; If can not meet the above requirements, when installation should be on the top of the evaporative condenser outlet installed on reducing ram, in order to improve the export wind speed and height of exhaust, reduce reflux.
冷庫蒸發式冷凝器的安裝也有單臺式和多臺并列式等安裝形式。安裝時需注意與鄰近建筑物的間距，一般要注意以下情況：
The installation of evaporative condenser in cold storage is also equipped with a single table and multiple side-by-side installations. When installing, pay attention to the space between adjacent buildings.
1.當蒸發式冷凝器四面都是墻時，安裝時進風口側的最小間距應為1800mm,非進風口側的最小間距為900mm。
When the evaporative condenser is on all sides of the wall, the minimum distance between the inlet and the inlet side should be 1800mm, the minimum spacing of the non-inlet side is 900mm.
2.當蒸發式冷凝器處于三面是實墻，_面是空花墻時，進風口側的最小間距應為900mm,非進風口側的最小間距為600mm。
When the evaporative condenser is on three sides of solid wall, _ face is an empty wall, the minimum distance between the inlet side should be 900mm, and the minimum spacing of the non-inlet side is 600mm.
3.當兩臺蒸發式冷凝器并聯安裝時，如兩者都是進風口側，它們之間的最小間距應為800mm;如—臺為進風口側，另一臺為非進風口側時，其最小間距為900mm；如兩臺都不是進風口側時，最小間距為600mm。
When two evaporative condenser is installed in parallel, the minimum distance between them should be 800mm. The minimum spacing is 900mm for the inlet side and the other side of the air outlet. If two are not in the inlet side, the minimum spacing is 600mm.
當蒸發式冷凝器采用同軸連接的離心式風機或水盤內設有電加熱器時，上述2、3兩種情況下，其最小間距應當加大，以利維修。
When evaporative condenser using coaxial connection centrifugal fan or water when the disc is equipped with electric heater, the above two cases, 2, 3, the minimum distance should be increased, and maintenance.
在保證蒸發式冷凝器與鄰近建筑物之間的距離后，在安裝時還要注意蒸發式冷凝器的水盤離地不宜小于500mm,以便于管道連接、水盤檢漏和防止地面臟物被風機吸入。
In guarantee the evaporative condenser and the distance between the adjacent buildings, also notice when installation of evaporative condenser water dish should not be less than 500 mm from the ground, so that the pipe connection, water leak detection and prevent the dirt on the suction fan.
在進行冷庫蒸發式冷凝器的配套安裝時，對于單組冷卻排管的蒸發式冷凝器與貯液器的進液配管，可用液體管本身進行均壓，水平管段的坡度為1/50,坡向貯液器。如閥門安裝位置受施工條件所限，可裝在主管上，但必須裝在出液口200mm以下。具體管道連接部分可參見第九節中關于蒸發式冷凝器管道連接方式等內容。
In the cold storage installation of form a complete set of evaporative condenser, cooling exhaust pipe for a single set of evaporative condenser and receiver into the fluid pipe, tube itself available liquid pressure, horizontal section of the slope at 1/50, slope to the receiver. If the valve installation position is limited to the construction conditions, it may be installed in the supervisor, but it must be installed below 200mm. The link section of the pipe can be seen in section 9 on the connection of the evaporative condenser pipe.
您如果對我們的產品感興趣或者有任何的疑問，您可以直接給我們留言或直接與我們聯絡，我們將在收到您的信息后，會第一時間及時與您聯絡。
If you are interested in our products or have any questions, you can directly give us a message or contact us directly, we will be in after receiving your information, will be the first time to contact you in time.