冷庫要合理調節冷庫蒸發器并及時除霜
Cold storage to be reasonable and timely adjust the refrigerator evaporator defrosting
一般而言，冷庫蒸發溫度每提高1℃，可節能2~2.5。因此，在能夠滿足產品制冷工藝的前提下，可通過調整供液量，盡量提高蒸發溫度。
醫藥冷庫
In general, the evaporation temperature refrigerator every increase 1 ℃, energy-saving 2 ~ 2.5. Therefore, under the premise that can satisfy the product cooling process, for fluid volume can be adjusted through, try to improve the evaporation temperature.
霜層的熱阻一般比鋼管的熱阻大得多，當霜層厚度大于10mm時，其傳熱效率下降30以上。當管壁的內外溫差為10℃、庫溫在-18℃時，排管蒸發器的制冷系統運行一個月后，其傳熱系數K值大約只有原來的70左右。
Frost layer thermal resistance of thermal resistance is much larger than steel tube, when the frost layer thickness is greater than 10 mm, its heat transfer efficiency is decreased by more than 30. When the tube wall temperature difference between inside and outside to 10 ℃ when - 18 ℃, libraries, temperature, discharge tube evaporator refrigeration system operation after a month, its heat transfer coefficient K value is only about 70 or so.
冷風機結霜特別嚴重時，不但熱阻增大，而且空氣的流動阻力增加，嚴重時將無法送風，所以要適時對蒸發器的表面進行除霜處理。
Air cooler frost particularly serious, not only the thermal resistance increases, and the air flow resistance increases, serious when will not be able to supply, so want to timely defrosting processing on the surface of the evaporator.
在大中型冷庫的制冷系統中，一般采用熱氨(氟)沖霜和水沖霜而不采用能耗高的電熱融霜方式，而小型氟利昂制冷系統為簡化管路，可采用電熱融霜方式，但是應根據霜層融化所需的熱量配置適宜的電熱功率。
In large and medium-sized cold storage refrigeration system, generally USES the hot ammonia gas defrosting (CFC) and water gas defrosting without using electric defrost mode of high energy consumption, and small freon refrigeration system to simplify the line, can use electric defrost mode, but should be based on the heat of the frost layer melts the required configuration is suitable for electric power.
本文由醫藥冷庫設備有限公司發表提供，詳情請關注公司網址：http://www.sddslk.com/
魯公網安備 37010402001149號 網站地圖 XML
